Hence, as the extraction process sucks it out, contaminants and bad odor are equally removed. Saturation allows the liquid to get to the padding and underneath. The liquid can be water, a solution of liquid detergent and water, or a stain remover. It is imperative that you saturate the spot with liquid, to achieve optimal performance with a subsurface extraction. The odor eater should deal with most of the mess whereas extraction should help clear the smell completely. As such, it is very important to use a highly efficient pet odor eliminator. Stains resulting from pet waste cause odor that is extremely difficult to remove. Some stains also require that you clean with water after soaking them with a stain remover. There are different methods for removing different kinds of stains. If the spot is as a result of something like coffee or pet urine, use the right product to pre-treat it. The whole purpose of the extraction tool is to pull water from there an underneath. Do not worry if water gets to the padding. Rinse with clean water and saturate it completely. Let the detergent soak, then scrub gently with a brush. Still, remember to avoid bleaching agents that can discolor your carpet permanently. Finish by rinsing off with clean water.Īn alternative approach is to pre-treat the spot with liquid detergent. Form the solution in a small bowl and apply on the section as you brush off the dirt. If a spot is as a result of dirty water, begin by cleaning it with soapy water. They do not require prior treatment because they leave a permanent or semi-permanent mark on the carpet. If your spot is just wet from clean water, you can go ahead with the extraction.Ĭlean water spots are easy to remove. Now that you have the equipment set and ready for the job, it is time to inspect the spot. This happens even with some tool models that are marketed as suitable for hoses of different sizes. In this case, you need to get an adapter. Results with a less powerful motor, leave a lot to be desired.ĭepending on the models of your machine and subsurface extraction tool, you might experience so difficulties while trying to fit the tool to the hose. Ideally, your machine’s motor should be 5 HP and above. In this case, the machine has to be a powerful shop vacuum. The first step for extracting moisture is fitting the tool to the hose your machine. Step 1: Fit the Tool to the Vacuum’s Hose All the same, you can use it for big spots by working with a small section at a time. It is not ideal for an entire carpet that is oversaturated with water. ![]() ![]() Ideally, sub surface carpet extraction tool is suitable for spot cleaning. It is not only possible to extract the moisture, but also the odor and stains. Similarly, there should be less anxiety if your old pet does its thing on your carpeted floor. As a result, you do not have to worry if a glass of water knocks over your carpet. The carpet extraction tool is suitable for all kinds of liquid dirt. As such, liquid contaminants are extracted from the carpet fibers, padding and underneath. This means that more suction power goes to the area that requires liquid extraction. 4 Advantages of Subsurface Extraction Subsurface Carpet Extraction ToolĪ subsurface carpet extraction tool is a machine extension that offers targeted vacuuming.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |